Drawing and fabricating a simple part using Fusion 360

Brad Goodman shares some tips on how to hold your torch when TIG Welding

How to make full penetration welds on aluminum butt joints

Brad Goodman (@deepsouthdimestacker) patches up a damaged fuel tank and shares his settings.

Today Brad welds at different ac frequencies and compares the results. Be sure to check out part 1 and 2 of Brad's AC Machine setup guide.

https://welderskills.vhx.tv/videos/basic-ac-machine-setup
https://welderskills.vhx.tv/videos/advanced-machine-settings

Brad welds some square tubing and shows us a useful tip

Welding an aluminum tread plate test cube

Testing #4, 5, and 6 cups as well as 6 gas lens, 8 gas lens and a FUPA 12.

Welding sleeves can be annoying, but probably less annoying than a uv burn. Brad shows us a pair of sleeves that will keep you safe and won't get in the way.

Choosing a torch is tricky. Brad shows us how he picks the right one for the job.

In part one, Brad gives a basic overview of how to set up an AC machine covering its functions, best practices, and some tips on how to navigate your own machine.

Brad shows us how to keep trash out of our welds.

Brad Goodman (@deepsouthdimestacker) shows us his CNC router and compares the results to a PlasmaCam. Also a good tip for dealing with aluminum shavings.

Brad shares a quick tip for fusion tacking

TIG welding an Aluminum dog feeder project

Brad sits down and chats about tungsten and grinders. Lots of tips in this one.

One of the biggest struggles for new aluminum TIG welders is learning to feed TIG wire. In my opinion, it's one of the hardest parts of aluminum TIG to get ahold on.

Today we're gonna look at how I prep my plasma cut aluminum plate for welding. I'm using an 80 grit sanding belt...