Live stream preview

Watch this video and more on WelderSkills

Watch this video and more on WelderSkills

3g MIG Plate Test

MIG > Certification Tests • 7m 8s

Up Next in MIG > Certification Tests

  • 3g MIG Plate Uphill Root

    Sometimes welding procedures specify downhill root and other times uphill is specified. It is great to be able to do both so you will be ready either way.
    uphill root voltage and wire settings are a bit lower but is really not more difficult than downhill once you nail the settings

  • One Simple MIG Welding Technique Tha...

    Can one Technique work for all positions?
    This simple technique basically just traces the front edge of the puddle where the rubber meets the road. But Cut and Etch testing is still one of the best ways to verify your technique and settings

  • Mig Welding Outside Corner uphill

    Mig Welding outside corner joints and testing them using the cut and etch test.
    C25 gas was used along with .035 (.9mm) ER70s-6 wire.
    Thermal Arc fabricator 252i welder (very finicky) was used.
    Uphill single pass weld tested against 2 pass weld with downhill root pass.
    mig welding settings and te...