Live stream preview

Watch this video and more on WelderSkills

Watch this video and more on WelderSkills

3g MIG Plate Uphill Root

MIG > Certification Tests • 5m 25s

Up Next in MIG > Certification Tests

  • One Simple MIG Welding Technique Tha...

    Can one Technique work for all positions?
    This simple technique basically just traces the front edge of the puddle where the rubber meets the road. But Cut and Etch testing is still one of the best ways to verify your technique and settings

  • Mig Welding Outside Corner uphill

    Mig Welding outside corner joints and testing them using the cut and etch test.
    C25 gas was used along with .035 (.9mm) ER70s-6 wire.
    Thermal Arc fabricator 252i welder (very finicky) was used.
    Uphill single pass weld tested against 2 pass weld with downhill root pass.
    mig welding settings and te...