Live stream preview

Watch this video and more on WelderSkills

Watch this video and more on WelderSkills

Stick Welding 7018 - Uphill Corner Joint 1/4" (6mm) thick hot rolled steel.

More Videos • 7m 7s

Up Next in More Videos

  • Tips for Passing Your Aluminum TIG We...

    You’ve probably read how aluminum needs to be really cleaned thoroughly before welding.
    A lot of aluminum can be tig welded without doing a whole lot of cleaning it really depends on the application.
    For general fabrication, often times a wipe with acetone or alcohol will do the trick if the me...

  • Don't make this Big Mistake - Overhea...

    Overhead welding with a 7018 can be done at the same amperage used for flat or horizontal, or close to it. Set the machine hot enough so that it won't stick when you hold a tight arc, and then... hold a tight arc.

  • TIG Welding Settings and Techniques f...

    16ga 6061 aluminum using 1/16" (1.6mm) 4043 filler.
    I used a tapered 2% lanthanated 3/32" (2.4mm) tungsten.
    Welding small aluminum coupons with a chill backing,
    This can also be done without backing but on small pieces of aluminum heat can saturate the piece and the puddle gets very watery.
    Chil...