-
Stick Welding Round Tube to plate using 7018 5/32" 5F position
Some Structural welders are being required to make welds like this 5F round tube to flat plate using 5/32" 7018. Here are a few tips on machine settings, arc length, and body positioning
-
Sam Hagan - Seeder Repair with 7018- stick welding
Sam fixes a seeder from the 60's using 7018.
-
Sam Hagan - 3 Point Hitch Repair with 7018
-
Matt Hayden Stick Welding Overhead Roof Top Weave 7018 1/8"
Matt Hayden Stick Welding Overhead Roof Top Weave 7018 1/8"
-
Sam Hagan - TMR (Cow Food) Mixer Repair
Repair on a TMR (Cow food) mixer. Process: Stick, Carbon Arc Gouging Material: Carbon Steel
-
Andrew Cardin - Stick Welding Overhead Round Tube to Plate 4f with 5/32" 7018
Welding Overhead 4F position tube to plate with 5/32" 7018 is a bit more challenging than with smaller electrodes but the same fundamentals apply for the most part.
Tight arc length, rod angle, and restarts are demonstrated with instructive arc shots and body positioning. -
Sam Hagan - Tractor Rim Repair
A look at a quick welding job on a tractor rim. This entire job took about 3 hours. Process used: MIG STICK | Materials used: Carbon Steel, 7018
-
Stick Welding a Carbon Steel 4F Tee Joint 7018
In this video...overhead welding at 130 amps with 7018 1/8" electrode.
One mistake I made in welding school was running too cold on overhead -
Stick Welding with big 3/16" 7024 Electrodes
In this video, I am stick welding with 3/16" 7024 rods on a multi pass weld on one inch thick carbon steel. Also show some welding with other commonly used stick electrodes
-
Stick Welding with 7018 - Carbon steel 3F tee joint
Amperage, Rod Angle, Arc Length are the key factors for stick welding vertical 7018 tee joints
-
Stick Welding Carbon Steel 2F multi pass Tee joint with 7018
One test beats out 100 opinions. Cut and etch testing of a multi pass fillet weld using 7018 stick electrodes