in this video, you will see tips for Stick Welding a multi pass fillet weld with 7014 along with a cut and etch test to check penetration
One test beats out 100 opinions. Cut and etch testing of a multi pass fillet weld using 7018 stick electrodes
Some welders are being required to use 5/32" 7018 for welding tests.
IF the procedure specifies 5/32" 7018 then that is what you have to use.
Andrew Cardin did the welding in this video while Jody handled the filming.
165 amps, arc force set to 10 using a Lincoln PowerMIG 210mp. We decided to use some leftover rods so that we show lots of restarts because being able to make a good restart is a fundamental skill... especially in overhe...