TIG Weld the Aluminum Hurricane (Part 1)
TIG > Aluminum • 11m
This video shows the butt joint portion of this aluminum hurricane project and how a #5 alumina cup can be the best choice for certain aluminum welds
Up Next in TIG > Aluminum
-
TIG Welding Aluminum Hurricane (Part 2)
This project was sent to me by a laser cutting company that sells them as weldable kits. It was a good practice project that required a lot of different torch angles. Rotating the torch head as you weld is shown along with plenty of instructive arc shots
-
TIG Welding Aluminum Outside Corner w...
The outside corner joint is a very common one. This video shows a slightly different perspective using aluminum angle. Same joint, different perspectives and some practice padding beads added.
-
TIG Welding Aluminum 1G Butt and 2F Tee
This Video gives tips for TIG welding a 1G flat butt joint and how to watch the puddle sink to make sure you are getting penetration,
A tee joint fillet weld test in 11 ga thickness usually requires penetration into the root but not all the way thru the back side